Kubota — SERVICING

03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE Fan Belt Damage and Wear 1. Check the fan belt for damage. 2. If the fan belt is damaged, replace it. 3. Check if the fan belt is worn and sunk in the pulley groove. 4. If the fan belt is nearly worn out and deeply sunk in the pulley groove, replace it. (A) Good (B) Bad W1020602 CAUTION When removing the radiator cap, wait at least ten minutes after the engine has stopped and cooled down. Otherwise, hot water may gush out, scalding nearby people. Radiator Cap Air Leakage 1. Set a radiator tester and an adaptor on the radiator cap. 2.

Apply the specified pressure 90 kPa (0.9 kgf/cm 2 , 10 psi), and measure the time for the pressure to fall to 60 kPa (0.6 kgf/cm 2 , 9 psi). 3. If the measurement is less than the factory specification, replace the radiator cap. W10387530 Radiator Water Leakage 1. Pour a specified amount of water into the radiator. 2. Set a radiator tester and an adaptor and raise the water pressure to the specified pressure. 3. Check the radiator for water leaks. 4. For water leak from the pinhole, replace the radiator or repair with the radiator cement. When water leak is excessive, replace the radiator. The pressure of the leak test is different from each radiator specification.

Thus, do the leak test, refer to the test pressure of each radiator specification. W10389070 S-25 KiSC issued 07, 2008 A Pressure falling time Factory spec. More than 10 seconds for pressure fall from 90 to 60 kPa (from 0.9 to 0.6 kgf/cm2, from 10 to 9 psi) Radiator water leakage test pressure Factory spec. No leak at specified pressure Q NOTE