Kubota — SERVICING

03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE Fuel Tightness of Delivery Valve [D1803-M-DI, V2403-M-DI, V2403-M-DI-T] 1. Remove the solenoid. 2. Remove the injection pipes and glow plugs. 3. Set a pressure tester to the fuel injection pump. 4. Install the injection nozzle (2) jetted with the proper injection pressure to the injection pump pressure tester (1). 5. Run the starter to increase the pressure. 6. Stop the starter when the fuel jets from the injection nozzle. After that, turn the flywheel by the hand and raise the pressure to approx. 18.63 MPa (190.0 kgf/cm 2 , 2702 psi). 7. Now turn the flywheel back about half a turn (to keep the plunger free).

Maintain the flywheel at this position and clock the time taken for the pressure to drop from 18.63 to 17.65 MPa (190.0 to 180.0 kgf/cm 2 , 2702 to 2560 psi). 8. Measure the time needed to decrease the pressure from 18.63 to 17.65 MPa (190.0 to 180.0 kgf/cm 2 , 2702 to 2560 psi). 9. If the measurement is less than allowable limit, replace the pump with new one or repair with a Kubota-authorized pump service shop. NOTE Q Never try to disassemble the injection pump assembly. For repairs, you are strongly requested to contact a Kubota- authorized pump service shop.

(1) Injection Pump Pressure Tester (2) Injection Nozzle (3) Protection Cover for Jetted Fuel W1108296 S-32 KiSC issued 07, 2008 A Fuel tightness of delivery valve Factory spec. 10 seconds 18.63 → 17.65 MPa 190.0 → 180.0 kgf/cm2 2702 → 2560 psi Allowable limit 5 seconds 18.63 → 17.65 MPa 190.0 → 180.0 kgf/cm2 2702 → 2560 psi