03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE Fuel Injection Pressure [D1503-M, D1703-M, D1803-M, V2003-M, V2203-M, V2403-M, V2403-M-T] [D1703-M-BG, V2003-M-BG, V2003-M-T-BG, V2203-M-BG, V2403-M-BG] 1. Set the injection nozzle to a nozzle tester. 2. Slowly move the tester handle to measure the pressure at which fuel begins jetting out from the nozzle. 3. If the measurement is not within the factory specifications, replace the adjusting washer (1) in the nozzle holder to adjust it. (Reference) Pressure variation with 0.025 mm (0.00098 in.) difference of adjusting washer thickness. Approx.
590 kPa (6.0 kgf/cm 2 , 85 psi) (1) Adjusting Washer W10476390 [D1803-M-DI, V2403-M-DI, V2403-M-DI-T] 1. Set the injection nozzle to a nozzle tester. 2. Slowly move the tester handle to measure the pressure at which fuel begins jetting out from the nozzle. 3. If the measurement is not within the factory specifications, replace the injection nozzle assembly. W10227280 S-34 KiSC issued 07, 2008 A Fuel injection pressure Factory spec. 13.73 to 14.70 MPa 140.0 to 150.0 kgf/cm2 1992 to 2133 psi Fuel injection pressure (1st stage) Factory spec. 18.64 to 20.10 MPa 190.0 to 205.0 kgf/cm2 2703 to 2915 psi