03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE Gear Case (for Side PTO Model) 1. Remove the gear case (1). 2. Remove the O-rings (2). (When reassembling) Replace the gear case gasket and O-rings. Check to see if there are four O-rings (2) inside the gear case (1). Apply a thin film of engine oil to the oil seal, and install it, noting the lip come off. Before installing the gear case gasket, apply a non-drying adhesive. (1) Gear Case (2) O-rings W1034671 Gear Case 1. Remove the hour meter gear case (if equipped). 2. Remove the gear case (1). 3. Remove the O-rings (2). (When reassembling) Replace the gear case gasket and O-rings (2). Replace the hour meter gear case gasket with new one.
Check to see if there are four O-rings (2) inside the gear case (1). Apply a thin film of engine oil to the oil seal (3), and install it, noting the lip come off. Before installing the gear case gasket, apply a non-drying adhesive. (1) Gear Case (2) O-ring (3) Oil Seal W1024531 Crankshaft Oil Slinger 1. Remove the crankshaft collar (3). 2. Remove the O-ring (2). 3. Detach the crankshaft oil slinger (1). (When reassembling) Insert the crankshaft collar (3) after install the gear case to cylinder body. (1) Crankshaft Oil Slinger (2) O-ring (3) Crankshaft Collar W1024731 Idle Gear 1. Remove the external snap ring. 2. Detach the idle gear collar. 3. Detach the idle gear (2).
(When reassembling) Check to see each gear is aligned with its aligning mark - Idle gear (2) and crank gear (4) - Idle gear (2) and cam gear (3) - Idle gear (2) and injection pump gear (1) (1) Injection Pump Gear (2) Idle Gear (3) Cam Gear (4) Crank Gear (5) Oil Pump Drive Gear W1024941 S-60 KiSC issued 07, 2008 A