03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE Piston Ring and Connecting Rod [D1803-M-DI, V2403-M-DI, V2403-M-DI-T] 1. Remove the piston rings (1), (2), (3) using a piston ring tool. 2. Remove the piston pin (8), and separate the connecting rod (6) from the piston (5). (When reassembling) When installing the ring, assemble the rings so that the manufacturer’s mark (12) near the gap faces the top of the piston (5). When installing the oil ring (3) onto the piston (5), place the expander joint (10) on the opposite side of the oil ring gap (11). Apply engine oil to the piston pin (8).
When installing the connecting rod (6) to the piston (5), immerse the piston (5) in 80 °C (176 °F) oil for 10 to 15 minutes and insert the piston pin (8) to the piston (5). Assemble the piston (5) to the connecting rod (6) with the FW mark (9) facing the flywheel side and the connecting rod mark (7) facing the injection pump side. NOTE Q Mark the same number on the connecting rod (6) and the piston (5) so as not to change the combination. (1) Top Ring (2) Second Ring (3) Oil Ring (4) Piston Pin Snap Ring (5) Piston (6) Connecting Rod (7) Mark (8) Piston Pin (9) FW Mark (10) Expander Joint (11) Oil Ring Gap (12) Manufacturer’s Mark W1127943 S-67 KiSC issued 07, 2008 A