03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE (6) Flywheel and Crankshaft Flywheel 1. Fit the stopper to the flywheel (1). 2. At first, remove two pieces of the flywheel screws (2). 3. Insert two pieces of the flywheel guide screws (3) in the holes. 4. Remove the all flywheel screws (2). 5. Remove the flywheel (1) slowly along the flywheel guide screws (3). (When reassembling) Insert two pieces of the flywheel guide screws (3). Check to see that there are no metal particles left on the flywheel mounting surfaces. Apply engine oil to the threads and the undercut surface of the flywheel bolt and fit the bolt.
(1) Flywheel (2) Flywheel Screw (3) Flywheel Guide Screws W1026863 Bearing Case Cover 1. Remove the bearing case cover mounting screws. First, remove inside screws (5) and then outside screws (3). 2. Screw two removed screws into the screw hole of bearing case cover (6) to remove it. IMPORTANT Q The length of inside screws (5) and outside screws (3) are different. Do not take a mistake using inside screws and outside screws. (When reassembling) Fit the bearing case gasket (1) and the bearing case cover gasket (2) with correct directions. Install the bearing case cover (6) to position the casting mark on it upward.
Apply engine oil to the oil seal lip and take care that it is not rolled when installing. Tighten the bearing case cover mounting screws with even force on the diagonal line. (1) Bearing Case Gasket (2) Bearing Case Cover Gasket (3) Bearing Case Cover Mounting Screw (4) Oil Seal (5) Bearing Case Cover Mounting Screw (6) Bearing Case Cover (a) Upside W10292140 S-68 KiSC issued 07, 2008 A Tightening torque Flywheel screw 98.1 to 107 N·m 10.0 to 11.0 kgf·m 72.4 to 79.5 lbf·ft Tightening torque Bearing case cover mounting screw 24 to 27 N·m 2.4 to 2.8 kgf·m 18 to 20 lbf·ft