03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE Crankshaft Before disassembling, check the side clearance of crankshaft. Also check it during reassembling. For D1503-M, D1703-M, V2003-M, V2203-M, D1703-M-BG, V2003-M-BG, V2003-M-T-BG and V2203-M-BG 1. Remove the main bearing case screw 2 (1). 2. Pull out the crankshaft assembly, taking care not to damage the crankshaft bearing 1 (3). For D1803-M and D1803-M-DI 1. Remove the main bearing case screw 2 (1). 2. Turn the crankshaft to set the crank pin of the third cylinder to the bottom dead center. Then draw out the crankshaft until the crank pin of the second cylinder comes to the center of the third cylinder. 3.
Turn the crankshaft by 2.09 rad (120 ° ) counterclockwise to set the crank pin of the second cylinder to the bottom dead center. Draw out the crankshaft until the crank pin of the first cylinder comes to the center of the third cylinder 4. Repeat the above steps to draw out all the crankshaft. For V2403-M, V2403-M-DI, V2403-M-T, V2403-M-DI-T and V2403- M-BG 1. Remove the main bearing case screw 2 (1). 2. Turn the crankshaft to set the crank pin of the 4th cylinder to the horizontal directions (Right or Left). Then draw out all the crankshaft, holding the crank pins to the horizontal directions (Right or Left).
(When reassembling) NOTE Q IMPORTANT Q Install the crankshaft sub assembly, aligning the screw hole of main bearing case 2 (2) with the screw hole of cylinder block. When tightening the main bearing case screw 2 (1), apply oil to the screw and screw by hand before tightening the specific torque. If not smooth to screw by hand, align the screw holes between the cylinder block and the main bearing case. (1) Main Bearing Case Screw 2 (2) Main Bearing Case 2 (3) Crankshaft Bearing 1 (a) Cut place for removing and installing the crankshaft [A] D1803-M, D1803-M-DI W1066311 S-69 KiSC issued 07, 2008 A Tightening torque Main bearing case screw 2 69 to 73 N·m 7.0 to 7.5 kgf·m 51 to 54 lbf·ft