Kubota — SERVICING

03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE Main Bearing Case Assembly 1. Remove the two main bearing case screws 1 (7), and remove the main bearing case assembly being careful with thrust bearing and crankshaft bearing. 2. Remove the main bearing case 1, 2 as above. (When reassembling) Clean the oil passage in the main bearing case. Apply clean engine oil on the bearings. Install the main bearing case assemblies in the original positions. Since diameters of main bearing cases vary, install them in order of makings (A, B for 3 cylinders and A, B, C for 4 cylinders) from the gear case side. Match the alignment numbers (1) and mark (2) on the main bearing case.

When installing the main bearing case 1 and 2, face the mark “FLYWHEEL” to the flywheel. Install the thrust bearing with its oil groove (8) facing outward. Confirm that the main bearing case moves smoothly after tightening the main bearing case screw 1 (7) to the specified torque. (1) Alignment Number (2) Alignment Mark (3) A (4) B (5) C (6) No Mark (7) Main Bearing Case Screw 1 (8) Oil Groove W1027366 S-70 KiSC issued 07, 2008 A Tightening torque Main bearing case screw 1 46 to 50 N·m 4.7 to 5.2 kgf·m 34 to 37 lbf·ft