Kubota — SERVICING

03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE Correcting Valve and Valve Seat NOTE Q Before correcting the valve and seat, check the valve stem and the I.D. of valve guide section, and repair them if necessary. After correcting the valve seat, be sure to check the valve recessing. 1) Correcting Valve 1. Correct the valve with a valve refacer. [D1503-M, D1703-M, D1803-M, V2003-M, V2203-M, V2403-M, V2403-M-T] [D1703-M-BG, V2003-M-BG, V2003-M-T-BG, V2203-M-BG, V2403-M-BG] [D1803-M-DI, V2403-M-DI, V2403-M-DI-T] 2) Correcting Valve Seat 1. Slightly correct the seat surface with a 1.0 rad (60 °) or 0.79 rad (45 °) valve seat cutter. 2.

Resurface the seat surface with a 0.52 rad (30 °) valve seat cutter or 0.26 rad (15 °) valve seat cutter to valve seat so that the width is close to specified valve seat width (2.12 mm, 0.0835 in.). 3. After resurfacing the seat, inspect for even valve seating, apply a thin film of compound between the valve face and valve seat, and fit them with valve lapping tool. 4. Check the valve seating with prussian blue. The valve seating surface should show good contact all the way around.

[D1503-M, D1703-M, D1803-M, V2003-M, V2203-M, V2403-M, V2403-M-T] [D1703-M-BG, V2003-M-BG, V2003-M-T-BG, V2203-M-BG, V2403-M-BG] [D1803-M-DI, V2403-M-DI, V2403-M-DI-T] (1) Valve Seat Width (2) Identical Dimensions (A) Check Contact (B) Correct Seat Width (C) Check Contact (a) 0.26 rad (15 °) or 0.52 rad (30 °) (b) 0.79 rad (45 °) or 1.0 rad (60 °) (c) 0.52 rad (30 °) or 0.26 rad (15 °) W10283500 S-78 KiSC issued 07, 2008 A Valve face angle Factory spec. IN. 1.0 rad 60 ° EX. 0.79 rad 45 ° Valve face angle Factory spec. IN. 0.79 rad 45 ° EX. 0.79 rad 45 ° Valve seat angle Factory spec. IN. 1.0 rad 60 ° EX. 0.79 rad 45 ° Valve seat angle Factory spec. IN. 0.79 rad 45 ° EX. 0.79 rad 45 °