03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE Valve Lapping 1. Apply compound evenly to the valve lapping surface. 2. Insert the valve into the valve guide. Lap the valve onto its seat with a valve flapper or screwdriver. 3. After lapping the valve, wash the compound away and apply oil, then repeat valve lapping with oil. 4. Apply prussian blue to the contact surface to check the seated rate. If it is less than 70 %, repeat valve lapping again. IMPORTANT Q When valve lapping is performed, be sure to check the valve recessing and adjust the valve clearance after assembling the valve. W10288140 Free Length and Tilt of Valve Spring 1.
Measure the free length (B) of valve spring with vernier calipers. If the measurement is less than the allowable limit, replace it. 2. Put the valve spring on a surface plate, place a square on the side of the valve spring. 3. Check to see if the entire side is in contact with the square. Rotate the valve spring and measure the maximum tilt (A) . If the measurement exceeds the allowable limit, replace it. 4. Check the entire surface of the valve spring for scratches. If there is any defect, replace it. W10289350 Valve Spring Setting Load 1. Place the valve spring on a tester and compress it to the same length it is actually compressed in the engine. 2. Read the compression load on the gauge.
3. If the measurement is less than the allowable limit, replace it. (A) Tilt (B) Free Length W10784360 S-79 KiSC issued 07, 2008 A Tilt (A) Allowable limit 1.0 mm 0.039 in. Free length (B) Factory spec. 41.7 to 42.2 mm 1.65 to 1.66 in. Allowable limit 41.2 mm 1.62 in. Setting load / Setting length Factory spec. 118 N / 35.0 mm 12.0 kgf / 35.0 mm 26.5 lbf / 1.38 in. Allowable limit 100 N / 35.0 mm 10.2 kgf / 35.0 mm 22.5 lbf / 1.38 in.