Kubota — SERVICING

03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE (2) Timing Gears Timing Gear Backlash 1. Set a dial indicator (lever type) with its tip on the gear tooth. 2. Move the gear to measure the backlash, holding its mating gear. 3. If the backlash exceeds the allowable limit, check the oil clearance of the shafts and the gear. 4. If the oil clearance is proper, replace the gear. For Balancer Model Only For Side PTO Model Only W1029564 Idle Gear Side Clearance 1. Set a dial indicator with its tip on the idle gear. 2. Measure the side clearance by moving the idle gear to the front and rear. 3. If the measurement exceeds the allowable limit, replace the idle gear collar.

W1029843 S-81 KiSC issued 07, 2008 A Backlash between idle gear and crank gear Factory spec. 0.04150 to 0.1122 mm 0.001634 to 0.004417 in. Allowable limit 0.15 mm 0.0059 in. Backlash between idle gear and cam gear Factory spec. 0.04150 to 0.1154 mm 0.001634 to 0.004543 in. Allowable limit 0.15 mm 0.0059 in. Backlash between idle gear and injection pump gear Factory spec. 0.04150 to 0.1154 mm 0.001634 to 0.004543 in. Allowable limit 0.15 mm 0.0059 in. Backlash between crank gear and oil pump gear Factory spec. 0.04150 to 0.1090 mm 0.001634 to 0.004291 in. Allowable limit 0.15 mm 0.0059 in. Backlash between idle gear and balancer gear (Intake side) Factory spec.

0.03500 to 0.1160 mm 0.001378 to 0.004566 in. Allowable limit 0.15 mm 0.0059 in. Backlash between cam gear and balancer gear (Exhaust side) Factory spec. 0.03500 to 0.1160 mm 0.001378 to 0.004566 in. Allowable limit 0.15 mm 0.0059 in. Backlash between crank gear and idle gear 2 Factory spec. 0.04150 to 0.1154 mm 0.001634 to 0.004543 in. Allowable limit 0.15 mm 0.0059 in. Backlash between idle gear 2 and hydraulic pump drive gear Factory spec. 0.03080 to 0.1062 mm 0.001213 to 0.004181 in. Allowable limit 0.15 mm 0.0059 in. Idle gear side clearance Factory spec. 0.12 to 0.48 mm 0.0048 to 0.018 in. Allowable limit 0.9 mm 0.04 in.