03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE Oil Clearance between Piston Pin and Small End Bushing 1. Measure the piston pin O.D. where it contacts the bushing with an outside micrometer. 2. Measure the small end bushing I.D. with an inside micrometer, and calculate the oil clearance. 3. If the oil clearance exceeds the allowable limit, replace the bushing. If it still exceeds the allowable limit, replace the piston pin. W1031982 Replacing Connecting Rod Small End Bushing (When removing) 1. Press out the used small end bushing using a small end bushing replacing tool. (See page “SPECIAL TOOLS” .) (When installing) 1.
Clean a new small end bushing and bore, and apply engine oil to them. 2. Using a small end bushing replacing tool, press in a new bushing taking due care to see that the connecting rod oil hole matches the bushing hole. (A) When removing (B) When installing W1032140 Connecting Rod Alignment NOTE Q Since the I.D. of the connecting rod small end bushing is the basis of this check, check bushing for wear beforehand. 1. Install the piston pin into the connecting rod. 2. Install the connecting rod on the connecting rod alignment tool. 3. Put a gauge over the piston pin, and move it against the face plate. 4.
If the gauge does not fit squarely against the face plate, measure the space between the pin of the gauge and the face plate. 5. If the measurement exceeds the allowable limit, replace the connecting rod. W10314620 S-87 KiSC issued 07, 2008 A Oil clearance between piston pin and small end bushing Factory spec. 0.014 to 0.036 mm 0.00056 to 0.0014 in. Allowable limit 0.15 mm 0.0059 in. Piston pin O.D. Factory spec. 25.004 to 25.011 mm 0.98441 to 0.98468 in. Small end bushing I.D. Factory spec. 25.025 to 25.040 mm 0.98524 to 0.98582 in. Connecting rod alignment Allowable limit 0.05 mm 0.002 in.