03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE (6) Oil Pump Rotor Lobe Clearance 1. Measure the clearance between lobes of the inner rotor and the outer rotor with a feeler gauge. 2. Measure the clearance between the outer rotor and the pump body with a feeler gauge. 3. If the clearance exceeds the factory specifications, replace the oil pump rotor assembly. W1035296 Clearance between Rotor and Cover 1. Put a strip of plastigage onto the rotor face with grease. 2. Install the cover and tighten the screws. 3. Remove the cover carefully, and measure the width of the press gauge with a sheet of gauge. 4. If the clearance exceeds the factory specifications, replace oil pump rotor assembly.
W1035444 (7) Starter Overrunning Clutch 1. Check the pinion and if worn or damage, replace the clutch assembly. 2. Check that the pinion turns freely and smoothly in the overrunning direction and does not slip in the cranking direction. 3. If the pinion slips or does not turn in both directions, replace the overrunning clutch assembly. NOTE Q Do not wash off the grease in the overrunning clutch with the chemicals or oils. W1156799 S-97 KiSC issued 07, 2008 A Clearance between inner rotor and outer rotor Factory spec. 0.030 to 0.14 mm 0.0012 to 0.0055 in. Allowable limit 0.2 mm 0.008 in. Clearance between outer rotor and pump body Factory spec. 0.11 to 0.19 mm 0.0044 to 0.0074 in.
Allowable limit 0.25 mm 0.0098 in. Clearance between inner rotor and cover Factory spec. 0.105 to 0.150 mm 0.00414 to 0.00590 in. Allowable limit 0.20 mm 0.008 in.