Kubota — GENERAL

03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM G GENERAL [11] CHECK POINTS OF EVERY 800 HOURS Valve Clearance IMPORTANT Q Valve clearance must be checked and adjusted when engine is cold. 1. Remove the head cover. 2. Align the mark line (3) on the flywheel and projection (2) on the housing so that the No.1 piston comes to the compression or overlap top dead center. 3. Check the following valve clearance (1) marked with “ , ” using a feeler gauge. 4. If the clearance is not within the factory specifications, adjust with the adjusting screw. NOTE Q The “1TC” mark line on the flywheel is just for No. 1 cylinder. There is no “TC” marking for the other cylinders. No.

1 piston comes to the top dead center position when the “TC” marking is aligned with the projection (2) in the window on flywheel-housing. Turn the flywheel 0.26 rad (15 ° ) clockwise and counterclockwise to see if the piston is at the compression top dead center or the overlap position. Now referring to the table below, readjust the valve clearance (1). (The piston is at the top dead center when both the IN. and EX. valves do not move; it is at the overlap position when both the valves move.) Finally turn the flywheel 6.28 rad (360 ° ) and align the “1TC” mark line and the projection (2) perfectly. Adjust all the other valve clearance as required.

After turning the flywheel counterclockwise twice or three times, recheck the valve clearance (1). After adjusting the valve clearance (1), firmly tighten the lock nut of the adjusting screw. (1) Valve Clearance (2) Projection (3) 1TC Mark Line W10113200 G-27 KiSC issued 07, 2008 A Valve clearance Factory spec. 0.18 to 0.22 mm 0.0071 to 0.0086 in. Valve arrangement Adjustable cylinder location of piston 3 Cylinder 4 Cylinder IN. EX. IN. EX. When No. 1 piston is at compression top dead center No. 1 , , , , No. 2 , , No. 3 , , No. 4 – – When No. 1 piston is at overlap position No. 1 No. 2 , , No. 3 , , No. 4 – – , ,