. MAINTENANCE SERVICE PROCEDURE REPLACE THE CUTTING EDGES, REVERSE AND REPLACE END BIT WARNING 4 - 26 CHECK ELECTRICAL INTAK Before the start of the cold seaso n (once a year), contact your Komatsu distri butor to have the el ectrical inta ke air heater repaired or checked for di D o not raise the blade unnecessarily high. Be sure not to put any part of your body und erneath the blade wh en blocking i Replace the cutting edge before it wears to the end face of the blade. Always replace the cutting edge a nd side edge when the distance from the blad e holder is less tha n 10 mm (0 .4 in).
If the mounting surface is worn, c orrect the mounting surface before replacing the cutting edge o r side edge. 1. Lift the blade to a suitable he 2. Remove bolts and nuts (1), th edge. 3. Clean the mounting face for c 4. Install a new cutting edge to t 5. If the cutting portion (outside) the side edges and install the the side edges. Tightening torque of mountin 6. After several hours of runnin 1. Lift the blade to a suitable he ight and put a block underneath the blade rai l to prevent it from 2. Remove bolts and nuts (1), th en remove end bit and the cutting edge. Clean the mounting face for c 4. Install a new cutting edge to t 5.
If the cutting portion (outside) of the side edge is worn, reverse the side edges and install the m on the opposite side, or replace the side edges. Tightening torque of mountin 6. After several hours of runnin Replacement of cutting edge for front blade (I f equipped) Replace the cutting edge with the same procedure as that of main blade. Since front blade does not have a blade guide rail, put a block efore work. under the support of front blade b