MAN — Removing and installing injection pump

Removing and installing injection pump Installing injection pump Fig. 5 Caution: If the injection pump is blocked the cam- shaft must on no account be loaded or turned because parts of the blocking pin may break off and fall into the governor. Non-compliance with this may result in severe damage to the injection pump. Remove screw plug А from governor housing. Take out blocking pin Б if fitted. 5 Fig. 6 Turn engine to angle for delivery start. Take cylinder head cover off cylinder no. 6 (fly- wheel end). When the cylinders are in crossover, the piston of cylinder no. 1 is at TDC at the end of the compression stroke. 6 Fig. 7 Check whether the injection pump is in delivery start position.

To do this, remove the screw plug from the governor housing (see Fig. 5). The deliv- ery start pointer must be visible in the centre of the inspection hole. Remove the mounting bolts from the injection pump drive gear (13 mm) so that it can be turned in the slots. Hold injection pump camshaft in place while turn- ing the gear (41 mm). Fit new O-ring (slightly coated with oil) to injection pump flange. 7 30 1 2