Removing and installing injection pump Fig. 8 Insert the injection pump and tighten the mounting bolts. 8 Fig. 9 Apply an initial torque of 5 Nm to all mounting bolts on the gear through the inspection hole. Two com- plete engine turns are necessary for this operation. Now tighten all mounting bolts to 30 Nm. Check delivery start, if necessary readjusting it (see page 25). Screw in screw plug on the governor housing and fit cover to timing case. Caution: Comply with instructions for masking unions on pressurised oil and fuel pipes (see page 3). 9 31