Repairing water pump Disassembling water pump The following special tools are required for disas- sembling and assembling the water pump: D Press D Improvised tools, see page 146. Fig. 1 Remove V-belt pulley. Pull off water pump hub with a stable three-arm puller. 1 Fig. 2 Unclip the circlip from the water-pump housing. 2 Press impeller off the shaft, using a suitable man- drel. For this purpose align water−pump housing horizontally on a stable support. Fig. 3 The picture shows an assembly device for this. If such a device is not available, use a support ring (special tool, see page 146). Use a suitable mandrel to press the water−pump shaft together with bearing out of the housing.
Shaft and bearing are encapsulated and ex- changed together only. 3 6 Fig. 4 Water pump disassembled 1 Hub 2 Circlip 3 Pump bearing 4 Housing 5 Axial face seal 6 Impeller 4 5 1 2 3 4 43