Checking valve timing Note: If the valve timing is incorrect, serious damage to the engine may result. For this reason, if faults occur in the en- gine which could lead to the shrunk-fitted camshaft gear turning, check that the gear is correctly seated by checking the valve timing. Carrying out a check after installation of the camshaft is also recommended. Fig. 1 1 Remove cylinder head cover from 1st cylinder. Set valve clearance of cylinder 1 correctly. Fig. 2 Turn engine over with cranking device until the valves of cylinder 1 are in cross-over. Turn engine back to approx. 50 _ before TDC, then forwards to 30 _ before TDC (observe graduation on flywheel). 2 Fig.
3 Apply dial gauge with approx 2 mm preload to valve spring retainer of exhaust valve in 1st cylin- der and set to “0”. Turn engine in running direction through 180 _ (exhaust valve fully closed). Read valve stroke from dial gauge. The valve stroke must be between 4.5 and 5.4 mm. 3 113