Removing and installing crankshaft Removing crankshaft D Remove oil pan and oil pump, see page 65 D Remove timing case, see page 108 D Remove front cover with crankshaft seal, see page 71 Fig. 1 Remove the bolts from the connecting rod bearing covers and put the covers aside, arranging them in the sequence of installation. Removing piston with connecting rod, see page 117. 1 Fig. 2 Remove horizontal bolts from crankshaft bearing caps. Fig. 3 Loosen and remove mounting bolts from crankshaft bearing caps in stages from the inside out. Take off bearing caps and arrange them in order of installation.
2 Take the bearing shell halves out of the bearing caps and lay them aside together with their respective bearing caps. Lift out crankshaft. Caution: Do not damage the rolling surfaces of the crankshaft bearing pins. Take the bearing shells out of the crankcase and lay them aside in the sequence of installation. Clean parts and check for wear, replacing them if necessary. 3 Fig. 4 The bearing covers are marked with regard to their sequence of installation. Note: Crankshaft bearing no. 1 is located at the non-flywheel end. 4 114