MAN Nutzfahrzeuge Aktiengesellschaft — Removing and installing crankshaft

Removing and installing crankshaft Checking spread of bearing shells Fig. 5 Position bearing shells together on flat surface. Measure and note down spread dimensions “ A and “ B Spread dimension = A−B B Installing crankshaft Fig. 6 A Clean oil ducts in crankcase and in crankshaft with dry compressed air. 5 Thoroughly clean bearing shells and bearing journals. Install bearing shells in crankcase, observing the numbering. Caution: Observe relevant repair stage when using new bearing shells. Apply oil to the running surfaces on the bearing shells and install crankcase, ensuring that the markings on the crankshaft and camshaft gears coincide. 6 Figs.

7 and 8 Check whether the bearing cover bolts comply with the max. permissible length (see “Service Data”). Bolts previously removed may be reused if the max. permissible length is not exceeded. Reassemble bearing caps with associated bearing shells. Insert vertical bearing cap screws and tighten to specified torque in stages from the inside out. Tighten finally by angle. Insert horizontal crankshaft bearing cap screws and tighten to specified torque. 7 Caution: As replacement for the lateral crankshaft bearing cap bolts now use only collar bolts 51.90020−0382 (M12x1.5x85, 12.9). Previously used bolts of other types must be replaced by these bolts. Check to see that crankshaft runs smoothly.

Caution: Faulty bearing caps cannot be replaced singly. 8 115