Checking and adjusting start of fuel delivery Adjusting start of delivery If the check according to method a) or b) should prove that the delivery start is not correct, proceed as follows: Fig. 9 On engine D 2842 LE 602 remove the charge−air pipe (arrow) between the two intake pipes. 9 Fig. 10 Remove timing case cover. Note: Pipelines are attached to the timing case cover. To facilitate reassembly, memorise or make a drawing or photograph of the positions of holders, pipe clamps, spacer sleeves etc. Fig.11 10 Turn engine to specified angle for delivery start. Fig. 12 Loosen all bolts fastening the drive gear to the in- jection pump hub.
For this, two complete turns of the engine are necessary. Turn the injection pump camshaft on the drive flange to the left or right until the conditions men- tioned under a) or b) apply. 11 Note: If the setting specified cannot be reached by turning the injection pump hub, the installation of the injection pump is to be checked. Tighten bolts for fastening drive gear to drive flange consecutively to 5 Nm and then to 38 Nm. Note: Use only M8x22 mounting bolts (property class 12.9). Check delivery start once again. Close governor housing. 12 32