MAN Nutzfahrzeuge Aktiengesellschaft — Removing and installing injection pump

Removing and installing injection pump Removing injection pump Note: The subsequent reinstallation of the in- jection pump is rendered considerably easier if before its removal the engine has been turned to start of delivery. See page 29. Fig. 1 D 2842 LE 602 Disconnect the flame glow plugs and remove the lines from the solenoid valve. Remove charge-air pipe between the intake pipes. 1 Fig. 2 Remove the injection lines from the injection pump and from the injection nozzles. 2 Fig. 3 After removal of the injection lines we recommend fitting caps to the connections on the injection nozzles and injection pump. This prevents dirt from getting into the injection system. Caution:

Dirt in the injection system causes: D nozzles to jam D the injection-pump drive gear to break 3 33