Repairing coolant pump Fig. 9 Turn coolant pump housing over. Press in new mechanical seal with press-fitting sleeve (special tool) until it stops. Observe installation note for seal on page 60. Note: The seal can be exchanged even without removing the coolant pump shaft. 9 Fig. 10 Slowly press impeller on to bearing shaft to ensure correct gap. 10 Fig. 11 For this purpose an inspection hole closed up with a screw plug (M16x1.5) is provided on the bottom of the water pump housing. 2 1 1 Impeller 2 Coolant pump housing 11 Fig. 12 Fit new pump cover and press it into housing, using a suitable pressing tool. 12 52