MAN Nutzfahrzeuge Aktiengesellschaft — Repairing coolant pump with high-temperature and low-temperature parts

Repairing coolant pump with high-temperature and low-temperature parts Coolant pump for three thermostats Fig.

1 and 2 1 2 1 Pump housing HT (high-temperature part) 2 Pump housing LT (low-temperature suction part) 3 Hub 4 Bolt DIN 931−M8x155, hex nut DIN 934−M8 5 Bolt DIN 933−M8x35−8.8 6 Mechanical seal 51.06520−0085 7 Impeller for coolant pump, HT circuit 8 Mechanical seal 51.06520−0099 9 Counterring complete 51.06520−0100 10 Impeller for coolant pump, LT circuit 11 Splash shield 12 Mechanical seal 51.06520−0096 13 Coolant pump bearing 14 Drive shaft for coolant pump 15 Circlip 16 Coolant pump seal 17 Grooved ball bearing 6003 18 Cap 3 5 4 1 18 6 7 8 9 10 11 12 13 14 17 16 2 15 Disassembling water pump Fig. 3 Removing the water pump, see page 48. Clamp water pump in a vice, use protective jaws.

Pull off boss with three-arm puller. 3 Fig. 4 Unclip the circlip from the coolant pump housing. 4 54