MAN Nutzfahrzeuge Aktiengesellschaft — Removing and installing, repairing oil pump

Removing and installing, repairing oil pump Refilling with oil 1 Caution: Do not add so much engine oil that the oil level rises above the max. marking on the dipstick. Overfilling will result in damage to the engine. Figs. 13 and 15 Refill with fresh engine oil at the oil filler neck А . After filling with oil disconnect electric connection from speed pickup. Turn engine over with starter until oil pressure warning lamp goes out / oil pres- sure gauge indicates pressure. Then restore electric connection to speed pickup. Then start the engine and allow it to run at medium speed for a few minutes. Check oil pressure and tightness of system. 13 Then shut down the engine.

After about 20 min- utes, check the oil level. D Pull out dipstick D wipe it with a clean, lintfree cloth D and push it in again up to the stop D Pull out dipstick again The oil level should be between the two notches in the dipstick and must never fall below the lower notch. Top up oil as necessary. 14 1 Oil ? 1 MAX MIN 15 68