Removing and installing vibration damper, changing front crankshaft seal Fig. 9 Special tools are required for installing the race. 1 2 Clean inner side of race and crankshaft stub. Coat crankshaft stub with sealing agent “Antipor 46”. D Push race Ж and pressing sleeve З onto adapter В D Tighten spindle А in adapter В with nut Г 7 D Bolt adapter В to crankshaft 9 3 5 6 4 Fig. 10 The adapter must contact the crankshaft free of play so that the correct pressing depth for the race is ensured. Pull in race using collar nut and pressing plate ( И and Й in Fig. 9) until pressing sleeve З stops on the adapter. Note: The bearing race can be installed even while the cover remains fitted.
10 2 5 1 Exchanging radial shaft seal Fig. 11 As spare parts the cover and shaft seal are deliv- ered only as a complete assembly in order to en- sure correct installation. To ensure that the shaft seal remains suitable for installation, it must remain on the transport and assembly sleeve until installed. Observe the remarks and assembly instructions on page 79. 11 Fig. 12 Fit cover А with new seal Б . The cylinder pins В provide better guidance for the cover. These will ensure that the seal is not too easily damaged when the cover is put on. 1 2 Tighten screws to specified torque. 3 12 73