MAN Nutzfahrzeuge Aktiengesellschaft — Removing and installing vibration damper, changing front crankshaft seal

Removing and installing vibration damper, changing front crankshaft seal Installing vibration damper Fig. 13 Fit oil splash ring to crankshaft. Place vibration damper on two guide pins (M16x1.5). Ensure that the position of the grad- uated disc relative to the crankshaft is correct. Tighten mounting bolts to specified torque. Fit cranking device. Fit and tension V-belts, see page 131. 13 Figs. 14 and 15 During assembly the delivery start indicator on the vibration damper may have moved out of correct adjustment. Therefore check whether the scale of degrees on the inspection hole cover of the flywheel housing (picture 14) and on the vibration damper (picture 15) indicate the same values.

If necessary readjust delivery start indicator. Caution: Unblock the crankshaft. 14 15 74