Operation Section Table 2. MI-07 Diagnostic Fault Codes (Flash Codes) cont’d. (*) Fault actions shown are default values specified by the OEM.
99 DFC PROBABLE FAULT FAULT ACTION * CORRECTIVE ACTION FIRST CHECK 572 MediumOverspeed Engine speed has exceeded the second level (2 of 3) of overspeed protection (1) TurnOnMil (2) MediumRevLimit Usually associated with additional ETC faults Check for ETC Sticking or other ETC faults Verify if the lift truck was motored down a steep grade 573 SoftOverspeed Engine speed has exceeded the first level (1 of 3) of overspeed protection (1) TurnOnMil (2) SoftRevLimit Usually associated with additional ETC faults Check for ETC Sticking or other ETC faults Verify if the lift truck was motored down a steep grade 611 (61) APP1RangeLow APP1 sensor voltage out of range low, normally set if the APP1 signal has shorted to ground, circuit has opened or sensor has failed (1) TurnOnMil (2) CheckEngine Light Check foot pedal connector Check APP1 signal at SECM PIN B7 612 (65) APP2RangeLow APP2 sensor voltage out of range low, normally set if the APP2 signal has shorted to ground, circuit has opened or sensor has failed TurnOnMil Check foot pedal connector Check APP2 signal at SECM PIN B16 621 (62) APP1RangeHigh APP1 sensor voltage out of range high, normally set if the APP1 signal has shorted to power or the ground for the sensor has opened 1) TurnOnMil (2) CheckEngine Light Check foot pedal connector Check APP1 signal at SECM PIN B7 622 (66) APP2RangeHigh APP2 sensor voltage out of range high, normally set if the APP2 signal has shorted to power or the ground for the sensor has opened TurnOnMil Check foot pedal connector Check APP2 signal at SECM PIN B16 631 (63) APP1AdaptLoMin Learned idle end of APP1 sensor range lower than expected None Check APP connector and pins for corrosion Cycle the pedal several times and check APP1 signal at SECM Pin B7 632 (67) APP2AdaptLoMin Learned idle end of APP2 sensor range lower than expected None Check APP connector and pins for corrosion Cycle the pedal several times and check APP2 signal at SECM Pin B16 641 (64) APP1AdaptHiMax Learned full pedal end of APP1 sensor range higher than expected None N/A 642 (68) APP2AdaptHiMax Learned full pedal end of APP2 sensor range higher than expected None N/A