Doosan — Doosan D60S-5 and G60S-5 Lift Truck Operation Manual

Operation Section Table 2. MI-07 Diagnostic Fault Codes (Flash Codes) cont’d . (*) Fault actions shown are default values specified by the OEM.

100 DFC PROBABLE FAULT FAULT ACTION * CORRECTIVE ACTION FIRST CHECK 651 APP1AdaptHiMin Learned full pedal end of APP1 sensor range lower than expected None N/A 652 APP2AdaptHiMin Learned full pedal end of APP2 sensor range lower than expected None N/A 661 APP1AdaptLoMax Learned idle end of APP1 sensor range higher than expected None N/A 662 APP2AdaptLoMax Learned idle end of APP2 sensor range higher than expected None N/A 691 (69) APP Sensors Conflict _ _ APP position sensors do no not track well, intermittent connections to APP or defective pedal assembly 1) TurnOnMil (2) Level1PowerLimit Check APP connector and pins for corrosion Cycle the pedal several times and check APP1 signal at SECM Pin B7 Cycle the pedal several times and check APP2 signal at SECM Pin B16 711 (71) LSDFault Dither1 _ Dither Valve 1 Fault, signal has opened or shorted to ground or power or defective dither 1 valve TurnOnMil Check FTV1 for an open wire or FTV connector being disconnected FTV1 Pin 1 (signal) to SECM Pin A1 FTV1 Pin 2 (power) to SECM (DRVP) Pin A23 Check FTV1 for an open coil by disconnecting the FTV connector and measuring the resistance (~26Ω ± 2Ω ) 712 LSDFault Dither2 _ Dither Valve 2 Fault, signal has opened or shorted to ground or power or defective dither 2 valve TurnOnMil Check FTV1 for an open wire or FTV connector being disconnected or signal shorted to GND FTV2 Pin 1 (signal) to SECM Pin A2 FTV2 Pin 2 (power) to SECM (DRVP) Pin A23 Check FTV1 for an open coil by disconnecting the FTV connector and measuring the resistance (~26Ω ± 2Ω ) 714 LSDFault CheckEngine _ Check Engine Lamp Fault, signal has opened or shorted to ground or power or defective check engine lamp None Check ‘Check Engine Lamp’ for an open wire or shorted to GND