Maintenance Section Every 1000 Service Hours or 6 Months You must read and understand the warnings and instructions contained in the Safety section of this manual, before performing any operation or maintenance procedures. Carburetor (LP - Gas Engine Only) - Adjust, Clean If the engine is hard to start or the exhaust is smoking, the carburetor may need cleaning and adjusting. Before adjusting the carburetor make sure the engine is at normal operating temperature. Park the lift truck with the forks lowered, parking brake applied, transmission in neutral and the engine stopped. For the complete procedure and specifications for your specific engine, see the " Service Manual ".
Fuel Filter - Check, Clean, Change 2. Remove fuel filter cartridge assembly. 3. Before installing a new cartridge assembly, apply a small amount of clean fuel to the filter cartridge gasket. Do not fill fuel filters with fuel before installing them. Contaminated fuel will cause accelerated wear to fuel system parts. NOTICE 4. Install the new fuel filter cartridge assembly. 5. Turn the new fuel filter cartridge assembly until the filter gasket is fitted against the sealing face. 6. Turn the fuel filter cartridge assembly an additional 2/3 of turn.
Air Intake System - Change Changing Primary Element Diesel Engine Park lift truck with the forks lowered, parking brake applied, transmission in neutral, engine stopped and cool. 1. Raise the right side cover. See topic, “Air Intake System - Check, Clean” in “Every 250 Service Hours or Monthly”. Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. Turn the disconnect switch OFF or disconnect the battery when changing fuel filters. Changing Secondary Element Replace the secondary element after the primary element has been cleaned three times or yearly. 1. Remove the primary air cleaner element. See topic “Servicing Filter Element”.
Clean the inside of the air cleaner housing and cover. 2. Remove the secondary element. Inspect the gasket between the air cleaner housing and the engine inlet. Replace the gasket if it is damaged. Typical Example Diesel Engine Truck 172 WARNING