Doosan — Doosan D60S-5 and G60S-5 Lift Truck Operation Manual

Maintenance Section Engine Oil & Filter(Diesel Engine Only) – Change Diesel Engine Crankcase Fuel Trim Valve(FTV) Inspection (G643E Engine only) z Visually inspect the Fuel trim valve(3) for abrasions or cracking. Replace as necessary. See topic, "Engine Oil & Filter (Diesel E/G Only) - Change" in "First 50-100 Service Hours or a Week". Inspect Vacuum Lines and Fittings (G643(E) Engine only) z To ensure the valve is not leaking a blow-by test can be performed. 1. With the engine off, disconnect the electrical connector to the FTV. 2. Disconnect the vacuum line from the FTV to the pressure regulator/converter, at the converter’s tee connection.

z Visually inspect vacuum lines and fittings for physical damage such as brittleness, cracks and kinks. Repair/replace as required. 3. ightly blow through the vacuum line connected to the FTV. Air should not pass through the FTV when de-energized. If air leaks past the FTV when de-energized replace the FTV. z Solvent or oil damage may cause vacuum lines to become soft resulting in a collapsed line while the engine is running. z If abnormally soft lines are detected, replace as necessary. Inspect Electrical System (G643E Engine only) 1 z Check for loose, dirty or damaged connectors and wires on the harness including:

Fuel lock-off, TMAP sensor, O2 sensor, Electronic throttle, Control Relays, Fuel Trim Valve, Foot Pedal, and Distributor sensor. 6 4 7 z Repair and/or replace as necessary 3 2 5 (1) LP fuel lock-off, (2) LP regulator/converter (3) Fuel Trim Valve(FTV) : G643E only) (4) LP mixer (5) Vacuum lines, (6) Coolant lines, (7) LP fuel line 171