Maintenance Section Check for Equal Tension Carriage Chain Adjustment - STD Mast Typical example for carriage chain of STD mast Typical example Lift the carriage and the mast high enough for getting tension on lift chains. Check the chains, and make sure the tension is the same. Lift chains are required to check for equal tension about every 1,000 service hours or 6 months. Make sure that carriage height is correct. If correct, adjust chain for equal tension. If not, adjust chain for correct carriage height by adjusting anchor nuts(1). NOTE: See the previous section, "Carriage Roller Extrusion" in "When Required" for proper carriage height. 1.
Fully lower the carriage and tilt mast forward or lift the carriage and put blocks under the carriage to release the tension from the lift chains. 2. Adjust nut(1) to get proper distance from the bottom of inner upright to the bottom of carriage bearing. 3. Make adjustment anchor nut(1) for equal chain tension. 4. Set the mast vertical and raise the carriage and check equal chain tension. If not equal, repeat the same procedure as step 1 through step 3. 5. Put LOCTITE No. 242 tread lock on the threads of the anchor nuts(1) after the adjustment is completed. Personal injury can be caused by sudden movement of the mast and carriage. Keep hands and feet clear of any parts that can move.
Lift Chain Adjustment Typical example for carriage equal tension If the tension is not the same on both chains, take the procedure as follows. NOTE: If carriage height is not correct, make adjustments by following procedures. 176 WARNING