Doosan — Doosan D60S-5 and G60S-5 Lift Truck Operation Manual

Maintenance Section Carriage Chain Adjustment - FFT Mast Chain Adjustment - FFT Typical example for carriage chain of FFT mast Typical example for FFT mast Make sure that carriage height is correct. if correct, adjust chain for equal tension. If not, adjust chain for correct carriage height by adjusting anchor nuts(2). NOTE: See the previous section, "Carriage Roller Extrusion" in "When Required" for proper carriage height. 1. Fully lower the carriage and tilt mast forward or lift the carriage and put blocks under the carriage to release the tension from the lift chains. 2.

Remove bolt(3), washer(4) and stopper(5) and adjust nut(2) to get proper distance from bottom of inner upright to the bottom of carriage bearing. 3. Make adjustment anchor nut(2) for equal chain tension. 4. Set the mast vertical and raise the carriage and check equal chain tension. If not equal, repeat the same procedure as step 1 through step 3. 5. Put LOCTITE No. 242 tread lock on the threads of the anchor nuts(2) after the adjustment is completed. Make sure that mast height is correct. If correct, adjust chain for equal tension. If not, adjust mast chain for correct mast height by adjusting anchor nuts(6). NOTE:

See the previous section, "Carriage Roller Extrusion" in "When Required" for proper inner mast height. 1. Lift the inner mast and put blocks under the inner mast to release the tension from the lift chains. 2. Adjust nut(6) to make inner mast bottom flush with outer mast bottom. 3. Make adjustment anchor nut(6) for equal chain tension. 4. Raise the inner mast and check equal chain tension. If not equal, repeat the same procedure above step 1 through step 3. 5. Put LOCTITE No. 242 tread lock on the threads of the anchor nuts(6) after the adjustment is completed. 177