Chassis - Hood and Mounting Section 100-0040 11. If required, remove locknuts (16), bolts (15), hood stops (20) and springs (21) from goalpost assembly (24). 6. Install washer bottle to mounting bracket on the left hand side of goalpost assembly (24) and secure using mounting hardware as removed during 'Removal'. 12. If required, remove mounting hardware securing hood blanking piece (41) to right hand fender. Remove hood blanking piece (41) from the machine. 7. Remove blanking caps from all cooling lines and connect cooling lines to radiator header tank as tagged at 'Removal'. Installation 8. Secure all hoses and harnesses to goalpost assembly (24) following routing as noted at 'Removal'.
Numbers in parentheses refer to Fig. 1. 9. Fill radiator header tank with coolant as specified in Section 210-0000, COOLING SYSTEM. Note: Tighten all fasteners to torques listed in Section 300-0080, STANDARD BOLT AND NUT TORQUE SPECIFICATIONS. 10. Lubricate hood catch mechanism. Use grease as specified in Section 300-0020, LUBRICATION SYSTEM. WARNING To prevent personal injury and property damage, be sure blocking materials and lifting equipment are properly secured and of adequate capacity to do the job safely. 11. Lower hood assembly and check for correct alignment between hood (1) and goalpost assembly (24) and for operation of hood catch mechanism. 12. Remove wheel blocks. 1.
If removed, secure hood blanking piece (41) to right hand fender with mounting hardware as removed at 'Removal'. MAINTENANCE Periodically check bolts (26), washers (27) and locknuts (28) and tighten when necessary. 2. If removed, secure hood stops (20) and springs (21) to goalpost assembly (24) with bolts (15) and locknuts (16). Periodically check condition of lock mechanism and adjust and lubricate when necessary. 3. Using suitable lifting equipment, lift and position goalpost assembly (24) on the machine. Secure goalpost assembly (24) to its mounting with bolts (25), washers (12), washers (13) and locknuts (11).
SPECIAL TOOLS There are no special tools required for procedures outlined in this section. Refer to Section 300-0070, SERVICE TOOLS, for part numbers of general service tools and adhesives required. These tools and adhesives are available from your dealer. 4. Remove lifting equipment. 5. Connect ball joint to cam assembly in hoodcatch kit (14) and secure cable assembly (22) using clips removed during 'Removal'. * * * * SM 2120 2-02 3