STRUCTURE AND FUNCTION OUTRIGGER CYLINDER OUTRIGGER CYLINDER 1. Cylinder 2. Piston rod with bearing eye 3. Piston 4. Cylinder head 6. Valve seat 7. Valve cone 8. Wiper (Dust seal) 9. Seal 10. Rod guide ring 11. O-ring 12. Backup ring 13. O-ring 14. Piston ring 15. O-ring 16. Backup ring 17. Piston guide ring 18. O-ring 19. Backup ring 20. O-ring 21. Backup ring 22. Relief valve spring 23. Plut 24. Nut 25. Grub screw 26. Bush 27. Circlip 28. Grease nipple 29. O-ring Cylinder head (4) guides the piston rod (2) which is sealed by seal (9). Seal (9) is protected against dirt by wiper (8).
Important Depressurizing the cylinder The check valve built into the cylinder prevents any cylinder movement due to oil leakage within the con- trol block or sudden loss of hydraulic pressure due to a hose burst. The built in check valve also holds hydraulic pres- sure within the cylinder when the hydraulic hoses are removed from the cylinder. When oil flows through port I tot he piston side of the cylinder the piston rod (2) extends out of the cylinder (1). The piston is guided in the cylinder (1) by the piston guide ring (7). It is sealed by the piston ring (14). The cylinder head is sealed against the cylinder by O- ring (13).
Depressurize the cylinder before opening When oil fows through port II to the rod side of the cylinder the piston rod retracts. To depressurize the cylinder, loosen the plug (23) carefully using an Allen key and wait until the pres- sure has been released. To be absolutely sure the plug can be completely removed. 10-127