STRUCTURE AND FUNCTION DOZER BLADE CYLINDER DOZER BLADE CYLINDER 1. Cylinder 2. Piston rod with bearing eye 3. Piston 4. Cylinder head 5. Valve seal 6. Check valve 7. Valve cone 8. Plug 9. Backup ring 10. Wiper (Dust seal) 11. Seal 12. Rod guide ring 13. Seal 14. 0-ring 15. Piston ring 16. O-ring 17. Backup ring 18. Piston guide ring 19. O-ring 20. O-ring 21. Backup ring 22. O-ring 23. Backup ring 24. O-ring 25. O-ring 26. Grub Screw 27. Nut 28. Relief valve spring 29. Nipple 30. Bush Cylinder head (4) guides the piston rod (2) which is sealed by seal (11). Seal (11) is protected against dirt by wiper (10).
The built in check valve also holds hydraulic pres- sure within the cylinder when the hydraulic hoses are removed from the cylinder. When oil flows through port I to the piston side of the cylinder the piston rod (2) extends out of the cylinder (1). The piston is guided in the cylinder (1) by the piston guide ring (18). It is sealed by the piston ring (16). The cylinder head is sealed against the cylin- der by O-ring (20). Depressurize the cylinder before opening To depressurize the cylinder, loosen the plug (8) carefully using an Allen key and wait until the pres- sure has been released. When oil flows through port II to the rod side of the cylinder the piston rod retracts.
To be absolutely sure the plug can be completely removed. Important Depressurizing the cylinder The check valve built into the cylinder prevents any cylinder movement due to oil leakage within the con- trol block or sudden loss of hydraulic pressure due to a hose burst. 10-128