STRUCTURE AND FUNCTION ENGINE CONTROL SYSTEM 1. OPERATION OF SYSTEM Starting engine When the starting switch is turned to the START position, the starting signal flows to the starting motor, and the starting motor turns to start the engine. When this happens, the engine throttle control- ler checks the signal from the fuel control dial and sets the engine speed to the speed set by the fuel control dial. Engine speed control The fuel control dial sends a signal to the en- gine throttle controller according to the position of the dial.
The engine throttle controller calcu- lates the angle of the governor motor according to the signal, and sends a signal to drive the governor motor so that it is at that angle. When this happens, the operating angle of the governor motor is detected by the potentiometer, and feedback is sent to the en- gine throttle controller, so that it can observe the operation of the governor motor. Stopping engine When the starting switch is placed at the OFF position, the shut off valve is closed so the sup- ply of fuel to the engine is shut off and the en- gine stops. 10-132