STRUCTURE AND FUNCTION ELECTRONIC CONTROL SYSTEM FUNCTION The following functions are available to provide the optimum matching under various working conditions: a cut-off function which reduces the relief loss; a function which cancels the cut-off function and prevents the speed from dropping; a 2-stage relief function which increases the digging power; and a fine control mode function which improves the ease of fine control.
1) LS control function The switching point (LS set differential pressure) for the pump discharge amount inside the LS valve is changed by changing the output pressure from the LS control EPC valve to the LS valve according to the engine speed and operating condition of the actuator. Because of this, the timing for starting the discharge amount from the pump can be optimized, to give excellent ease of com- pound operation and fine control. # For details of the operation, see HYDRAU- LIC PUMP.
2) Cut-off function If the load becomes larger during opera- tion, and the pump discharge pressure rises too close to the relief pressure, the pump pressure sensor detects this, and the controller sends a signal to the PC valve to reduce the discharge amount, thereby reducing the relief loss. # For details of the operation, see CLSS. 3) Cut-off cancel function The cut-off cancel function acts to stop the operation of the cut-off function in order to ensure the pump flow when close to the relief pressure, thereby preventing any drop in speed.
The relief pressure when the cut-off is op- erated is 31.85 MPa (325 kg/cm 2 ), and when the cut-off cancel function is oper- ated, the relief pressure becomes approx. 34.79 MPa (355 kg/cm 2 ). Actuation conditions for cut-off cancel function 10-144 Workingmodeswitch Swinglock Switch Knobswitch H/O G/O,F/O, B/O L/O TravelON ON OFF ON OFF Cut-off function Cancelled Actuated Cancelled Cancelled Cancelled Actuated Cancelled Actuated 2-stagerelief function - - Actuated Actuated Actuated - Actuatedat H/O,G/O -