Komatsu — FUNCTION

STRUCTURE AND FUNCTION ELECTRONIC CONTROL SYSTEM 2) Engine overheat prevention function This function protects the engine by lowering the pump load and engine speed to prevent overheating when the engine coolant tempera- ture has risen too far. This system is actuated in two stages. The first stage is when the coolant temperature is be- tween 102 ° C and 105 ° C, and the second stage is when the coolant temperature is 105 ° C and above. Normal operation (coolant temperature below 102 ° C) 1st stage (Coolant temperature between 102 ° C and 105 ° C) 2nd stage (Coolant tem- perature 105 ° C and above) 10-152 Actuation condition Normal operation Coolant tempera- ture:

below 102°C (Coolant tempera- ture gauge: Green range) Actuation condition 1st stage Coolant tempera- ture between 102°C and 105°C (Coolant tempera- ture gauge: Red range) Actuation, remedy Cancel condition Coolant temperature: Working mode Below 102°C Heavy-duty Mode kept as it When the above condition stage General is, output is met, the system returns Finishing reduced to the condition before the Breaker 2nd overheat prevention function was actuated Lifting Lifting operation (automatic reset). kept as it is ) Actuation, remedy Cancel condition Working mode In any mode Coolant temperature: Below 102°C Engine speed Low idling Fuel control dial:

Return stage temporarily to low idling Monitor caution Lights up position. 2nd lamp When the above conditions are met, the system returns Caution buzzer Sounds to the condition before the overheat prevention function was actuated (manual reset). Cancel condition 2nd stage Coolant temperature: Below 102°C When the above condition is met, the system returns to the condition before the overheat prevention function was actuated (automatic reset). Cancel condition 2nd stage Coolant temperature: Below 102°C Fuel control dial: Return temporarily to low idling position.

When the above conditions are met, the system returns to the condition before the overheat prevention function was actuated (manual reset). Actuation, remedy Working mode Heavy-duty General Finishing Breaker Mode kept as it is, output reduced Lifting Lifting operation kept as it is Actuation condition 2nd stage Coolant tempera- ture 105°C and above (Coolant tempera- ture gauge: Red range) Actuation, remedy Working mode In any mode Engine speed Low idling Monitor caution lamp Lights up Caution buzzer Sounds