Komatsu — TABLE OF JUDGEMENT STANDARD VALUE

TESTING AND ADJUSTING TABLE OF JUDGEMENT STANDARD VALUE Machine model PW130-6 20-7 Cate- gory Item Measurement conditions Unit Standard value Permissible value Travel Leakage of travel motor(s) • Engine at high idling • Hydraulic oil temperature: 45-55°C • Apply park brake and relieve travel circuit l /mm 30 - Work equipment Hydraulic drift of work equipment Total work equipment (hydraulic drift at tip of bucket teeth) Posture for measurement • Place in above posture and measure extension or retraction of each cylinder and downward movement at tip of bucket teeth • Bucket: Rated load • Horizontal, flat ground • Levers at neutral • Engine stopped • Hydraulic oil temperature:

45-55°C • Start measuring immediately after setting. • Measure hydraulic drift every 5 minutes, and judge from results for 15 minutes. mm Max. 460 Max. 700 Boom cylinder (amount of retraction of cylinder) Max.8 Max. 12 Arm cylinder (amount of extension of cylinder) Max.90 Max. 90 Bucket cylinder (amount of retraction of cylinder) Max. 40 Max. 40 Work equipment speed Boom Bucket teeth in contact with ground  Cylinder fully extended Engine at high idling • Hydraulic oil temperature: 45-55°C RAISE sec. 3.8±0.3 Max. 4.4 LOWER 2.9±0.3 Max. 3.5