Komatsu — TESTING AND ADJUSTING HYDRAULIC PRESSURE IN WORK EQUIPMENT, SWING, TRAVEL CIRCUIT

TESTING AND ADJUSTING TESTING AND ADJUSTING HYDRAULIC PRESSURE IN WORK EQUIPMENT, SWING, TRAVEL CIRCUIT TESTING AND ADJUSTING HYDRAULIC PRESSURE IN WORK EQUIPMENT, SWING, TRAVEL CIRCUIT MEASURING # Hydraulic oil temperature when measuring 45 - 55 ° C Lower the work equipment to the ground and stop the engine. Loosen the oil filler cap slowly to re- lease the pressure inside the hydraulic tank. Then put the safety lock lever in the LOCK posi- tion. Remove pressure pick-up plug (1) (Thread dia.=10mm, Pitch=1.25mm) from the circuit to be measured, then install oil pressure gauge C1 (58.8 MPa (600 kg/cm 2 ). Measuring unload pressure 1.

Measure the oil pressure in H/O mode with the engine at high idling and the control levers at neu- tral. Measuring pump relief pressure 1. Oil pressure when main relief pressure is at low pressure (31.9 MPa (325 kg/cm 2 )) 1) Measure the pressure when each actuator except the travel is relieved in H/O mode with the engine at high idling. # Note that the set pressure of the safety valve for the swing motor is lower than the main relief pressure, so the value measured will be the relief pressure of the safety valve. If the swing lock switch is turned ON, the pressure will rise, so always keep the lock switch OFF when measuring [engage the swing lock pin]. 20-26