TESTING AND ADJUSTING TESTING SOLENOID VALVE OUTPUT PRESSURE TESTING SOLENOID VALVE OUPUT PRESSURE Measuring # Oil temperature when measuring 45 - 550C 1. Measuring output pressure of ON/OFF solenoid valve 1) Disconnect outlet hose (1) of the solenoid valve, then use adapter C3 in the oil pressure gauge kit to install oil pressure gauge C1 (5.9 MPa {60 kg/ cm 2 }). 2) Measure the output pressure under the condi- tions in Table 1. Note: The condition of the solenoid valves is as follows. When ON: Current flows (hydraulic pressure is generated) When OFF: Current does not flow (hydraulic pressure:
0 MPa {0 kg/cm 2 }) However, the condition of the LS bypass and ac- tive mode solenoids is as follows. When ON: Current flows (hydraulic pressure 0 MPa {0 kg/cm 2 }) When OFF: Current does not flow (hydraulic pressure:
2.9 MPa {30 kg/cm 2 }) Table 1 20-34 Measurementconditions Operating condition Conditionof solenoid Oilpressure (MPa{kg/cm2} 1 Swingholding brake Swingorworkequipmentlever operated Brake canceled ON 2.9± 0.5 {30± 5} Allleversexcepttravelatneutral (5secafterreturningtoneutral) Brake actuated OFF 0 2 Travelspeed selection TravelspeedselectionswitchatHi •Enginespeed1,500rpmorabove •Travelleveroperated Travel speedHi ON 2.9± 0.5 {30± 5 Motorswash plateangleat minimum TravelspeedselectorswitchatLo orenginespeed1,500rpmor below Travel speedLo OFF 0 Motorswash plateangleat maximum 3 2-stagerelief SwinglockswitchON+work equipmentleveroperated Pressure rise ON 2.9± 0.5 {30± 5} Allleversatneutral OFF 0 4 Suspension lock SuspensionlockswitchON Suslock actuated ON 2.9± 0.5 {30± 5} SuspensionlockswitchOFF Suslock canceled OFF 0