Komatsu — TESTING TRANSMISSION CLUTCH CONTROL CIRCUIT

TESTING AND ADJUSTING TESTING TRANSMISSION CLUTCH CONTROL CIRCUIT TESTING TRANSMISSION CLUTCH CONTROL CIRCUIT DESCRIPTION (30 kph versions only) The transmission clutch acts to dis-engage the rear travel motor from the transmission at travel speeds above 12 ± 1 kph. It has a fully automatic control system which provides an actuation pressure applied from the park brake circuit via a pressure reducing valve and a control valve. The control valve is piloted by a control pressure which delivers from a gear pump on the transmission (which de- livers a flow directly proportional to road speed) and is regulated by an orifice of diameter 2.1 mm (clutch control orifice).

There is a pressure relief valve across this orifice which cracks open at 20 kg/cm 2 to prevent overpressuri- sation of the circuit, and a check valve to prevent operation of the clutch in rewards travel. 1. Measuring clutch actuation pressure Oil temperature 45 - 55 ° C Fit a tee connector to the clutch actuation port (1) and fit a 150 kg/cm 2 pressure gauge to the third leg of the tee. Measure pressure with the wheels lifted from the ground and rotating at maximum speed (pedal fully depressed) in Ho mode high idle (forwards travel). 20-38