TESTING AND ADJUSTING ADJUSTING TRAVEL MOTOR RELIEF PRESSURE ADJUSTING TRAVEL MOTOR RELIEF PRESSURE The value controlling deceleration of forwards travel is lo- cated on the left side of the motor (facing forwards) which is the same side as ports Pa and Ma. It is on the opposite side to the measurement port for forwards travel, Mb. The value controlling deceleration of rewards travel, simi- larly located on the right side (Ppt Mb side) of the motor. Remove the seal and cap from the valve. Loosen the locking nut with an M19 spanner. Turn the adjustment screw with a 6 mm Allen key, clockwise to increase, and counterclockwise to de- crease the pressure. Tighten the locknut. Note :
The set pressure cannot be measured whilst making an adjustment. Always repeat the measurement to check the set pressure after adjusting. 20-37