TESTING AND ADJUSTING TESTING TRAVEL MOTOR RELIEF PRESSURE TESTING TRAVEL MOTOR RELIEF PRESSURE The front (26-80 cc/rev) travel motor has two pressure re- lief valves which control the deceleration of the machine (when travelling and the travel pedal is in neutral). One op- erates in forward travel and one in reverse. # Set pressure = 37.3 MPa (380 kg/cm 2 ). Measuring travel motor Relief pressure Oil temperature should be 45 - 55 ° C Fit a 600 kg/cm 2 pressure gauge to port Mb on the front travel motor. Test the machine on a downhill slope with a smooth surface and long enough to allow the pressure to sta- bilize.
If the slope is steep (more than 5 degrees) test in Mi mode, otherwise test in Hi mode. Travel forward at approximately half maximum speed (for the selected mode), then release the travel pedal. Read the pressure gauge after the pressure stabi- lizes. If necessary repeat the test in reverse gear but with the pressure gauge fitted to port Ma (opposite site to Mb on front motor). 20-36 WARNING Take extreme care traveling at high speeds in re- verse.