TESTING AND ADJUSTING CLUTCH CONTROL CIRCUITS COMPONENTS CLUTCH CONTROL CIRCUITS COMPONENTS 3. MEASURE CLUTCH CONTROL PRESSURE # Oil temperature to be 45 - 55 ° C for all measurements Measure pressure at clutch control valve input port L (pilot port). Fit a tee connection at clutch control valve input (pilot line) and attach pressure gauge (60 kg/cm2) to the third leg of the tee. Measure pressure with the wheels lifted off the ground and rotating at maximum speed (pedal fully depressed) in Ho mode high idle (forwards travel). JUDGMENT TABLE # Always adjust pressure relief valve when in Hi travel mode (as in check item 1). SAFETY NOTE :
Do not attempt to measure pressure at the clutch pump output port directly as there is no internal relief valve. 20-40 Travelmode Pressurevalve MPa(kg/cm2) Remarks 1 Hi 2.4± 0.5 (25± 5) Ifpressureisoutsidetoleranceadjustpressurereliefvalveincontrol orificemanifold. 2 Mi 0.64± 0.15 (6.5± 1.5) Ifpressureislowadjustpressurereliefvalveincontrolorifice manifold.* Ifpressureishighcheckcontrolorificeforblockageand correctsize(2.1mmdiameter)