Komatsu — TESTING CLUTCH CONTROL CIRCUIT

TESTING AND ADJUSTING TESTING CLUTCH CONTROL CIRCUIT TESTING CLUTCH CONTROL CIRCUIT 4. ADJUSTING CLUTCH CONTROL PRESSURE RE- LIEF VALVE Adjust whilst measuring the clutch control pressure in Hi travel mode (Ho mode Hi idle) with the wheels off the ground and rotating at maximum speed (forwards direc- tion). 4.1 Break seal and remove cap . 4.2 Loosen locknut with a 19 mm wrench. 4.3 Turn the pin with a 6 mm Allen key To INCREASE pressure, turn CLOCKWISE. To DECREASE pressure, turn COUNTERCLOCKWISE. 4.4 After adjustment, tighten locknut and refit cap . TARGET:

2.4 ± 0.5 MPa (25 ± 5 kg/cm 2 ) CHECKING FOR CORRECT OPERATION OF THE CLUTCH After any adjustment check for correct operation of the clutch as follows. 1. Prepare to measure the clutch actuation pressure (as section 1). 2. With the wheels on or off the ground run the machine in forwards travel in Mi travel mode at maximum speed. Clutch actuation pressure should remain (clutch engaged) at zero^. Without stopping, switch to Hi mode. The wheels will start to increase in rotating speed and the clutch should immediately dis-engage. (at 11 ± 2 kph travel speed). Clutch actuation pressure will rise to 48 ± 2 kg/cm 2 and a change in noise from the travel motors will be heard. 20-41