TESTING AND ADJUSTING MEASURING OIL LEAKAGE 20-45 MEASURING OIL LEAKAGE # Hydraulic oil temperature when measuring 45 - 55°C 1. Work equipment cylinder # If the hydraulic drift of the work equipment is out- side the standard value, measure the leakage in- side the cylinder as follows, and judge if the cause of the hydraulic drift is in the cylinder or in the con- trol valve. • If leakage is within the standard value, the problem is in the control valve. • if the leakage is greater than the standard value, the problem is in the cylinder. 1) Fully extend the rod of the cylinder to be meas- ured, then stop the engine.
2) Disconnect piping (1) at the head end, then block the piping at the chassis end with a blind plug. Be careful not to disconnect the piping at the bottom end. 3) Start the engine and apply the relief pressure to the bottom end of the cylinder with the engine at high idling. 4) Continue this condition for 30 seconds, then measure oil leakage for the next one minute.