TESTING AND ADJUSTING RELEASING REMAINING PRESSURE IN HYDRAULIC CIRCUIT 2. Swing motor 1) Disconnect drain hose (1) from the swing motor, thenfit a blind plug at the tank end. 2) Turn the swing lock switch ON. 3) Start the engine and operate the swing relief with the engine at high idling. 4) Continue this condition for 30 seconds, then measure the oil leakage for the next one minute. # After measuring, swing 1800 and measure again. 3. Travel motor 1) Disconnect drain hose (2) from the travel motor, then fit a blind plug at the hose end. 2) Apply park brake. 3) Start the engine and operate the travel relief with the engine at high idling.
When measuring the oil leakage from the travel motor, mistaken operation of the control valve may lead to a serious accident, so always use sig- nals and check when carrying out this operation. 4) Continue this condition for 30 seconds, then measure the oil leakage for the next one minute. # When measuring, move the motor slightly (to change the position between the valve plate and cylinder, and piston and cylinder), and measure several times. RELEASING REMAINING PRESSURE IN HYDRAULIC CIRCUIT # No accumulator is installed, so the pres- sure remaining in the piping between the control valve and the hydraulic cylinder or swing motor cannot be released by operating the control levers.
Therefore, when removing the above piping, be careful of the following points. 1. Run the engine at low idling, operate the hydraulic cyl- inders so that they are not relieved at the end of the stroke, lower the work equipment to the ground, then stop the engine. # If the engine is stopped with the cylinder relieved at the end of the stroke, wait for 5 - 10 minutes before starting the operation. 2. When removing the piping, gradually loosen the sleeve nut of the piping to slowly release the pressure remaining in the piping. Remove the piping when the oil stops spurting out. 20-46